|
|||||||
|
|
|
|||||
|
|
|||||||
Cusco
Lower Arm Bar
Cusco Lower Arm Bar:
Tools needed:
12mm socket wrench
Ramps help too
This was very easy to install. My initial concern was if the bar would fit
or not with the differential protector. As you can see it fits with very
little room to spare. They supplied a backing plate that I suppose you
were to use on the other side of the holes in the cross member. My 99' RS
has nuts welded on the other side of the holes so I didn't need to use the
plates. I purchased the bar from Teague's Auto.
